#Bookshelf 2 feet wide full

Again, I wanted this to look like furniture, not like something from Ikea or Target, and I didn't feel a need to have adjustable shelves, so I went with the dadoes. Most plans for similar cubbies/bookcases have supports for the shelves and the shelves are removable. So if I'm making repeat cuts, the stop makes them very consistent. Also, I built a table for my miter saw that has flip-out arms with an aluminum track and a stop block on it. If I were buying a new miter, I would buy a sliding bevel miter, but I couldn't justify getting a new saw when mine still works pretty well. ( sliding miters typically cut 12 inches) A lot of the true woodworkers on this site would probably shake their head at this, but, you can cut a board 2/3 the way across with your regular miter, then flip it over and just site down the cut line and get a really consistent cut. I have a miter saw, but I don't have a sliding miter saw, so technically I can only cut a board 8 inches wide. I made all of the rip cuts first and then cut down the lengths. If the piece you want is to the left, then add the width of the blade to the measurement).

( If the waste side is to the left, then place the mark and the jig right where you want to make the cut.

There are tons of plans on line, but the basic idea is to make a straight edge that abuts the base of your saw, and a leading edge that marks where the blade is going to cut. The jig is super simple to make and really effective. I also built a simple jig out of hardboard to rip the plywood into straight pieces approximately a foot wide. I don't own a table saw, so I bought an 80 tooth blade for my circular saw. These will be listed in italics, so if you want to skip them, ignore anything written on a slant. I am going to list all the mistakes I made and things I learned on the way. I get frustrated with plans in magazines and on line that assume you know a lot of basic steps. Although I think this bookcase turned out nicely, it's a pretty simple plan. There are some people on this site who do some beautiful, complex work. I also thought this would give me an excuse to buy some new tools!Ĭaveat: I am very new to woodworking, so this is a pretty basic project. This is for my daughter's bedroom, but I wanted something that would be beautiful and substantial-something you could proudly display in your living room if you wanted to. Her plans use a bunch of pocket holes to hold everything together, but I wanted to do something a little more 'woodworkery' with some joinery and finishing. There's a nice little video there and it all looks quite easy. Ana White has something like this over at her website here: To finish the enclosure, we selected high gloss black and white finishes to highlight the features of this beautiful speaker.I couldn't find plans for a similar cubby on line.

In doing this we sacrificed no details by making sure no fasteners were visible allowing the speaker to show enhancing smooth lines of the cabinet and magnetically attached grilles. The patented wave guide design improves tweeter to woofer blend and significantly improves off-axis response for consistent performance over a wide listening area. Low/Mid range frequency response is supported by 6.5” Aluminum cone woofers featuring low-distortion motor-structures for greater clarity and accuracy with improved sensitivity and output capability. High frequency response is supported by 1 inch aluminum dome tweeters that were derived from Revel’s Performa3 series. It will deliver an impressive combination of wide frequency range, uncompressed dynamic range and low distortion across the entire audible spectrum.

#Bookshelf 2 feet wide full

The M16 is a true full range 2-way 6.5” bookshelf that features a small footprint and elegant design.